Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   - Equipment of service, tool and workplace equipment
      Equipment of service
      Fixture
      Sizes of fixture
      Procedure and order of a tightening of carving connections
      Dismantling of components
      Prokladochnye of a surface
      Councils on removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions
Ремонт эбу рав 4 тут.
Honda 1 .


Councils on removal of hoses

If your car is equipped with air central air, at all do not disconnect from conditioner components any hoses until the system will not be discharged in representation office of the company or the expert in central airs of air of a workshop of car-care center.

Measures of precautions which should be observed at removal of hoses are very close to that at removal of laying. Avoid damage of surfaces of unions and branch pipes on which hoses as it can be at the bottom of emergence of leaks put on. In a special measure it belongs to procedure of removal of hoses of a radiator. Owing to various chemical reactions occurs "prikipany" rubbers of hoses to interfaced surfaces of unions and branch pipes. For hose removal first of all weaken a collar of fastening it on the union. Then nippers with the sliding hinge seize a hose near a collar and start to rotate it on the union / a connecting branch pipe to the right-to the left. Continue this procedure before hose liberation, then remove a hose from the union. A small amount of silicone or other greasing will facilitate procedure if it can be entered into a gap between the union and a hose. For simplification of procedure of installation of a hose grease an internal surface of a hose and an external surface of the union.

As the last resort, or in case of unequivocal need of replacement of a hose for the new end of a hose put on the union for removal can be knifed and then is separated from an union surface. Thus try not to damage a knife union metal / under a connecting branch pipe.

In case of damage of a collar of fastening of a hose replace it with the new. Collars of braided type usually weaken eventually therefore, regardless of their condition, as required it is better to replace them with collars of screw type.