Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   - Equipment of service, tool and workplace equipment
      Equipment of service
      Fixture
      Sizes of fixture
      Procedure and order of a tightening of carving connections
      Dismantling of components
      Prokladochnye of a surface
      Councils on removal of hoses
      Tool
      Workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions



Workplace equipment

Speaking about the tool, it is necessary to remember the workplace equipment. If carrying out more serious work, than simple maintenance is necessary, it is necessary to take care of preparation of the suitable worker of a platform.

It is necessary to recognize that many motorists are compelled to perform removal of the engine and other similar works far not in the conditions of garage or a workshop. However, in any case the important requirement is roof or awning existence.

Whenever possible, any procedures on dismantling of parts of systems of the car should be made on a pure flat workbench, or a strong table of convenient height. The workbench should be surely equipped with a vice. Existence of a vice with disclosure of sponges to 100 mm and with soft overlays for sponges is sufficient.

As it was already mentioned above, on a working platform the pure dry place for storage of the tool, lubricant and cleaning liquids, shpaklevka, paint and varnish materials, etc. should be equipped.

It is necessary to notice that absolutely necessary tool is the electrodrill, therefore, the working platform should be equipped with the power supply for its connection. Drill existence with the boss to 9.5 mm and a set of qualitative drills considerably will facilitate carrying out many procedures.

At last, on a workplace always there should be a sufficient stock of old newspapers and pure, not ворсящейся the rags, intended for cleaning of a working platform, the tool and car details.

It is necessary to hand over working off in the centers for utilization in tight container.

Never perform any works on the barefaced painted surface of the car, use protective overlays for wings, or, at the worst, cover the polished surfaces with old blankets.