Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
- Automatic transmission
   General information
   Diagnostics of malfunctions - the general information
   Removal and installation of the lever of switching
   Check of a condition and adjustment of a cable of switching
   The description, replacement and adjustment of a cable of a drive of a butterfly valve in a mode kik-Down (TV cable)
   Serviceability check, adjustment and replacement of the sensor switch of permission of start
   Adjustment of a cable of a lay blokirator
   Check of a condition and replacement of a support of transmission
   Epiploon replacement
   Design description, removal and installation of lines and hoses of cooling of transmission
   Removal and installation of an additional cooler
   Removal and installation of automatic transmission
   Replacement of the module of management with transmission (TSM) (only for AW-4 and 42RЕ)
   Diagnostics of system of electronic control by automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions



Removal and installation of the lever of switching

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Remove the handle from the lever of switching of transmission. Grasp it and sharply pull, having removed from the lever.
  3. Remove the console (Head the Body).
  4. Give fixing screws and remove a console arm (Head the Body).
  5. Give nuts of fastening of assembly of the lever of switching to a basic cover of the panel of a floor.

Components of assembly of the lever of switching of transmission.

  1. Lift assembly of the lever of switching, having provided with that access to cables.
  2. Disconnect switching and blocking cables (See. Sections Check of a condition and adjustment of a cable of switching and Adjustment of a cable of a lay blokirator respectively).
  3. Remove assembly of the lever of switching.
  4. Installation make upside-down.