Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
- Suspension bracket and steering
   General information
   Removal and installation of the forward stabilizer of cross-section stability and its plugs
   Removal and installation of forward shock-absorbers
   Removal and installation of a cross-section jet bar of a forward suspension bracket
   Removal and installation of levers of a forward suspension bracket
   Removal and installation of screw springs of a forward suspension bracket
   Removal and installation of rotary fists
   Replacement of spherical hinges
   Removal and installation of a bar of the back stabilizer of cross-section stability
   Removal and installation of back shock-absorbers
   Removal and installation of a cross-section jet bar of a back suspension bracket
   Removal and installation of levers of a back suspension bracket
   Removal and installation of screw springs of a back suspension bracket
   Removal and installation of a steering wheel
   Condition check, removal and installation of a steering drive
   Removal and installation of the steering mechanism
   Removal and installation of the pump of system of hydrostrengthening of a wheel
   Pumping of system of hydrostrengthening of a wheel
   Wheels and tires - the general information
   Corners of installation of forward wheels - the general information
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions



Removal and installation of screw springs of a back suspension bracket

 PERFORMANCE ORDER

  1. Weaken nuts of forward wheels. To Poddomkratta a car front also establish it on props. Remove wheels.
  2. Mark situation and disconnect from the holder of a crosspiece of a leading gear wheel of differential the forward driveshaft (Head Coupling and the transmission line), then tie up a shaft aside a piece of a wire.
  3. Prop up assembly of the bridge or one jack established under differential, or two, got under everyone their sleeves (the last way gives the best balancing). To Otboltita the bottom levers of a suspension bracket from the bridge (The section Removal and installation of levers of a forward suspension bracket).
  4. To Otboltita of a rack of the stabilizer and shock-absorbers from a forward part of a case of the bridge (The sections Removal and installation of a bar of the back stabilizer of cross-section stability and Removal and installation of back shock-absorbers).
  5. Disconnect a jet bar from a bridge arm (The section Removal and installation of a cross-section jet bar of a back suspension bracket).
  6. Slowly omit bridge assembly so that screw springs were completely stretched. If for a podpiraniye of the bridge one jack is used only, ask the assistant to hold the bridge on the right at its lowering. Take a spring from under the car.
  7. Check a spring on existence of defects and traces of corrosion which are capable to cause a premature exit it out of operation. In case of need make replacement.
  8. Installation make upside-down. Make sure of correctness of landing of a screw spring (see an illustration). All fixture tighten with demanded effort.