Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
- Power supply system and production of the fulfilled gases
   General information
   Procedure of dumping of pressure of fuel
   Check of pressure of fuel and functioning of the fuel pump
   Removal and installation of a fuel tank
   Cleaning and repair of a fuel tank - the general information
   Repair and replacement of fuel lines
   Removal and installation of the fuel pump
   Check of serviceability and replacement of the block of the fuel level sensor
   Removal and installation of assembly of an air purifier
   Replacement of a cable of gas
   System of injection of fuel - the general information
   Check of serviceability of system of injection of fuel
   Serviceability check, removal and installation of the case of a throttle
   Check of serviceability and replacement of a regulator of pressure of fuel
   Serviceability check, removal and installation of injectors of fuel
   Check of functioning and replacement of components of system of stabilization of turns of idling (IAC)
   Service of system of production of the fulfilled gases - the general information
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions



Removal and installation of the fuel pump

See the prevention at the beginning of the Section Procedure of dumping of pressure of fuel.


 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Dump pressure in a power supply system (The section Procedure of dumping of pressure of fuel).
  3. Remove a fuel tank (The section Removal and installation of a fuel tank).
  4. Remove ventilating lines and/or the fuel hoses limiting an approach to a cover of access to the fuel pump.
  5. Carefully tapping on external edge of a cover with a screw-driver, give a cover, rotating it counter-clockwise. Uncover assembly.
  1. Carefully tapping with a screw-driver or a stupid drift on external edge of a cover, give it, rotating counter-clockwise.
  1. Take the fuel pump from a tank.
  1. Taking the fuel pump from a tank, try not to damage poplavkovy assembly of the fuel level sensor.
  1. In default the pump it should be replaced together with the fuel level sensor. An individual order any of blocks (the pump and the sensor) is not subject to service.
  2. Installation make upside-down. Do not forget to establish new laying on a cover flange.