Jeep Grand Cherokee

1993-1999 of release

Repair and car operation


Jeep Grandee Cheroki
- Jeep Grand Cherokee brand cars
   + Identification numbers of the car
   Acquisition of spare parts
   + Equipment of service, tool and workplace equipment
   + Poddomkrachivaniye and towage
   Engine start from the auxiliary power supply
   + Automobile himikaliya, oils and greasings
   + Diagnostics of malfunctions
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions

Engine start from the auxiliary power supply

At engine start from the auxiliary battery it is necessary to remember need of implementation of the following requirements:

  • Before connection of the auxiliary battery make sure that ignition is switched off (a key will turn in the situation OFF).
  • Make sure that all electric equipment of the car (lighting devices, a heater, screen wipers, etc.) is switched off.
  • Surely put on goggles.
  • Make sure that the auxiliary battery on target tension corresponds established on your car.
  • If start is made from the battery established on other car, track, that between cars there was no common ground!
  • Make sure, transmission is established on neutral transfer (RKPP), or to the situation "R" (Parking) (AT).
  • If the auxiliary battery belongs to type of subjects to service, remove from it ventilating covers and cover openings with rags.

Connect a red wire from a set for engine start from an auxiliary source between positive (+) plugs of both batteries. Then connect the second (black) wire from a set at first to the negative (-) the plug of the auxiliary battery, and then to well earthed point on your car (such as a bolt or an arm on the engine block, whenever possible within distance in 45 cm from the battery). Make sure that wires do not touch moving components of an impellent compartment (such as fan blades, driving belts, etc.).

Connect wires from a set for car start from the auxiliary power supply as it should be shown in drawing (pay attention that the negative wire of NOT auxiliary battery is connected to the negative plug of the sat-down battery).

Start the engine from the auxiliary battery, then, having left it working at single turns, turn on the motor of the fan of a heater (for the maximum speed) or a heater of glass for smoothing of peaks of tension which can arise at a detachment of wires (do not turn on lighting devices since considerable power surges can lead to a peregoraniye of lamps). Disconnect wires, operating as it should be the return to an order of their connection.