Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
- Body
General information
Care of a body
Care of the panels of furnish made of vinyl
Care of an upholstery and salon rugs
Repair of insignificant damages of body panels
Repair of considerable damages of a body
Service of loops and locks
Replacement wind and motionless glasses
Removal, installation and adjustment of provision of a cowl
Removal and installation of the lock of a cowl and cable of its drive
Removal and installation to the place of the panel of a decorative front grille
Removal and installation of a forward wing
Removal and installation of bumpers
Removal and installation of the panel of an internal upholstery of a door
Removal, installation and adjustment of provision of a door
Removal and installation of handles, cylinder and clamp (latch) of the lock of a door
Removal and installation of a windowpane of a door
Removal and installation of a regulator of a window of a door
Removal and installation of the central console
Removal and installation of the panel of an upholstery of a door of a back
Removal, installation and adjustment of provision of a door of a back
Replacement of an emphasis of a door of a back
Removal and installation of facing of a combination of devices
Removal and installation of facings of a control panel
Removal and installation of a control panel
Removal and installation of covers of a casing of a steering column
Removal and installation of rear-view mirrors
Remove also installation of a lattice of a fairing
Removal and installation of seats
Control body sizes
+ System of onboard electric equipment
+ Governing bodies and operation receptions
|
Removal and installation of the panel of an internal upholstery of a door
|
|
- Disconnect a negative wire from the battery.
- Give screws of fastening of an upholstery and an armrest.
|
|
- Screw-driver with a crosswise sting unscrew screws of fastening of the panel of an internal upholstery of a door.
|
|
|
- Give the screw of an upholstery located in an armrest.
|
|
|
- Give the fixing screw, then hook a facing cover of the internal handle of a door.
|
- On models with a manual drive of lowering-podnimaniya of glasses remove the drive handle.
- Pass the special tool for an otpuskaniye of clamps of the panel of an upholstery of a door (ask in shops of automobile accessories) or a shpaklevochny knife between the panel of a covering and a door and release clamps. Moving on perimeter of the panel of an upholstery, finally release it.
- After an otpuskaniye of all clamps disunite electric sockets of plaits of wires under the panel of an upholstery and remove the last from a door.
|
|
- Delay the upholstery panel from a door and disunite electric sockets of plaits of wires passing under it.
|
- For ensuring access to an internal surface of a door carefully separate from it the plastic water filter.
|
|
- Carefully separate from an internal surface of a door the plastic water filter - try not to tear and not to deform it.
|
- Before installation of the panel of an internal upholstery of a door make sure that all clamps which in the course of removal could remain actually at doors are inserted into it.
- Connect electric sockets of wires and put the upholstery panel to a door in the adjusting situation. Serially latch all clamps.
- Establish into place an armrest and the handle of a drive of lowering-podnimaniya of glass.
|
|
|
|
