Check of a condition and replacement of the breaker of indexes of turn / alarm system
|
All considered models are equipped with a safety cushion. The pillow constantly is in the "guarded" condition and can work to (be inflated) at any moment at the connected battery. In order to avoid casual operation of a pillow (and receiving as a result of a trauma) each time at carrying out any works with components of system of safety disconnect a negative wire from the battery. After a wire detachment from the battery before starting to work wait at least two more minutes (the system is equipped with the condenser to which needs time for a discharge). In more detail about work of system of safety see. The section Safety cushion - the general information. |
The breaker of indexes of turn / the alarm system represents a kanistroobrazny form the relay providing a blinking of lamps of indexes of turn / the alarm system at turning on of the corresponding switch. On models of 1993 вып. two separate blocks are established on a back wall of the service center under the dashboard from its driver's party. Models of 1994 вып. are equipped with one combined breaker placed in a box of the relay in a ware box (The Relay section - the general information).
|
Breakers of indexes of turn and alarm system.
|
Regularly functioning breaker publishes at work well distinguishable aurally clicks. Refusal of functioning of one of turn indexes being accompanied increase of frequency of clicks of the breaker speaks about failure of the corresponding lamp.
Simultaneous refusal of both indexes of turn can be caused by safety lock failure, defect of the breaker, malfunction of the switch or violation of quality of contact or conducting break in a contour. If external survey revealed combustion of a safety lock of a contour before making its replacement check electroconducting on existence of short circuit.
For breaker replacement simply take it from the socket and insert on its place the new.
Track that the new breaker was identical on type old.
|