Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
- Settings and routine maintenance
   - Schedule of routine maintenance of Jeep Cherokee
      Introduction
      General information on settings
      Checks of levels of liquids (each 400 km (250 miles) run or weekly)
      Check of a condition of tires and pressure in them (each 400 km (250 miles) run or weekly)
      Check of level of liquid of automatic transmission (each 400 km (250 miles) run or weekly)
      Check of level of liquid of system of hydrostrengthening of a wheel (each 4800 km (3000 miles) run or times in 3 months)
      Change of impellent oil and the oil filter (each 4800 km (3000 miles) run or times in 3 months)
      Check and battery service (each 4800 km (3000 miles) run or times in 3 months)
      Check of serviceability of system of cooling (each 4800 km (3000 miles) run or times in 3 months)
      Check of a condition and replacement of hoses passing under a cowl (each 4800 km (3000 miles) run or times in 3 months)
      Check of a condition and replacement of brushes of screen wipers (each 4800 km (3000 miles) run or times in 3 months)
      Check of a condition of a suspension bracket and steering
      Check of a condition of system of production of the fulfilled gases (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of level of transmission oil of a manual transmission (RKPP) (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of level of oil of a transfer case of all-wheel drive (4WD) of models (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of level of oil of differential (each 12 000 km (7500 miles) run, or times in 6 months)
      Rotation of wheels (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of a condition of brake mechanisms (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of a condition of components of a power supply system (each 12 000 km (7500 miles) run, or times in 6 months)
      Condition check, adjustment of a tension and replacement of a driving belt (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of a condition of seat belts (each 12 000 km (7500 miles) run, or times in 6 months)
      Check of functioning of the sensor switch of permission of start (only models with AT) (each 12 000 km (7500 miles) run, or times in 6 months)
      Chassis greasing (each 12 000 km (7500 miles) run, or times in 6 months)
      Replacement of the air filter (each 48 000 km (30 000 miles) run, or times in two years)
      Replacement of liquid and the filter of automatic transmission (each 48 000 km (30 000 miles) run, or times in two years)
      Adjustment of tapes of automatic transmission (AT) (model since 1994 вып.) (each 48 000 km (30 000 miles) run, or times in two years)
      Replacement of transmission oil of a manual box (switching) of transfers (RKPP) (each 48 000 km (30 000 miles) run, or times in two years)
      Change of oil of a transfer case (4WD model) (each 48 000 km (30 000 miles) run, or times in two years)
      Change of oil of differential (each 48 000 km (30 000 miles) run, or times in two years)
      Service of system of cooling (an oporozhneniye, washing and filling) (each 48 000 km (30 000 miles) run, or times in two years)
      Check of a condition and replacement of the valve of system of operated ventilation of a case (PCV) (V8) engines (each 48 000 km (30 000 miles) run, or times in two years)
      Check, pro-cleaning and replacement of a hose of system of continuous ventilation of a case (CCV) (6 cylinder engines) (each 48 000 km (30 000 miles) run, or times in two years)
      Check of serviceability of functioning of system of catching паров fuels (each 48 000 km (30 000 miles) run, or times in two years)
      Cleaning of the filter of ventilation of a case (V8) engines (each 48 000 km (30 000 miles) run, or times in two years)
      Replacement of the fuel filter (each 48 000 km (30 000 miles) run, or times in two years)
      Replacement of spark plugs (each 48 000 km (30 000 miles) run, or times in two years)
      Check of a condition of candle wires, covers and a distributor begunka (each 48 000 km (30 000 miles) run, or times in two years)
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


Service of system of cooling (an oporozhneniye, washing and filling) (each 48 000 km (30 000 miles) run, or times in two years)

Antifreeze is aggressive and poisonous liquid therefore it is necessary to avoid hit it on open sites of a body and the painted surfaces of the car. Casually got splashes immediately wash away a plentiful quantity of water. Do not leave a cooler spilled on a floor of garage or being stored in open container - the sweetish smell of antifreeze can easily draw to itself attention of children and animals. Hit even insignificant quantity of a cooler in an organism is fraught with serious consequences, up to a lethal outcome. Before starting to plum of a cooler consult in dealer office about rules of its utilization. In many regions special points on reception of poisonous working off of internal combustion engines are created.

In order to avoid development of corrosion and different formation of the deposits influencing overall performance of the engine and capable to become the reason of its damage to result of an overheat, it is necessary to make regularly oporozhneny systems of cooling, its washing and filling by a fresh mix. During service of system of cooling the condition of all its hoses and a radiator cover should be checked. Replacement of defective components is in case of need made.

 PERFORMANCE ORDER

  1. Cock the parking brake and block wheel (wedges).

If the car was just used before starting to work wait for some hours necessary for cooling of the engine.

  1. Establish under the drain union of a radiator capacity of large volume for cooler reception in it. The drain stopper of a radiator on the models equipped with 6-cylinder engines is located in the right lower part of a radiator, on models with the V8 engine - at the left. If it is obviously possible, put on the drain union a hose in diameter about 10 mm for the most exact correction of the direction of a stream of following liquid in drain capacity, then open the union gate (for its turn probably it is necessary to use flat-nose pliers).
  2. After a full oporozhneniye of a broad tank of system uncover a radiator, having provided plums of liquid and from it. Then move capacity under a drain stopper of the block of the engine - on the V8 engine from each party of the block is available on one such stopper, on the 6-cylinder engine the stopper is located on the right wall of the block. Remove a stopper let's to a cooler flow down from the block.

Often the cooler does not start to follow from the block after stopper removal. Obstruction of a drain opening by a rust the crossing point from which is formed at once behind a stopper appears the reason of this phenomenon usually. Punch a crossing point a screw-driver.


On 6-cylinder engines the drain stopper (arrow) is located on the left wall of the block, is direct under a final collector.

On V8 engines the block of cylinders is equipped with two drain jams - on one from each of the parties.

  1. While the cooler follows check a condition of radiatorny hoses, hoses of a heater and all shlangovy collars (see. The section Check of a condition and replacement of hoses passing under a cowl (each 4800 km (3000 miles) run or times in 3 months)).
  2. Replace all damaged hoses and collars.
  3. After a final oporozhneniye of system wash out a radiator fresh water from a garden hose. Washing continue until pure water will not start to follow from a radiator. The stream of water will remove traces of deposits from internal surfaces of a radiator, but cannot deduce from system products of corrosion and a scum.
  4. Last of the mentioned products are deduced by a chemical way by means of a special cleaner - follow instructions of manufacturers. In case of serious corrosion or damage of a radiator it should be removed (The head of System of cooling, heating and air conditioning) and to send in special repair shop.
  5. Disconnect from a broad tank perelivny a hose of a radiator and wash out a tank pure water, then connect a hose into place.
  6. Close and tighten the gate of the drain union of a radiator. Establish on a place and tighten a drain stopper (and) the engine block.
  7. Transfer the handle of management of heater operating modes to the maximum situation.
  8. Slowly add in a radiator a fresh cooler (50 % an antifreeze mix with water). The gulf continue before radiator filling. Add a cooler in a broad tank of system to its bottom label.
  9. Having left a cover of a radiator opened, start the engine (the car should be established in well ventilated room or in the open air). Wait thermostat opening (the cooler will start to circulate on a radiator and the top hose of the last will get warm).
  10. Switch off the engine and let's to it cool down. Add necessary quantity of a cooler for lifting of its level aflush with sponges of a jellied mouth of a radiator.
  11. Compress the top hose of a radiator, having expelled from it air, then, in case of need, add still a cooler. Establish into place a radiator cover.
  12. Start the engine, let's to it get warm to normal working temperature and check system on existence of leaks.