Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
- Systems of cooling, heating and air conditioning
   General information
   Antifreeze - the general information
   Check of functioning and thermostat replacement
   Check of serviceability and replacement of the fan of system of cooling and coupling of its coupling
   Check of functioning and replacement of the block of the sensor of temperature of a cooler
   Removal and installation of a radiator and broad tank of system of cooling
   Check of functioning of the water pump
   Removal and installation of the water pump
   Check of serviceability of an electric contour and replacement of components of the motor of the fan of a heater and air conditioner
   Removal and installation of the block of the fan of a heater
   Removal and installation of assembly of management by a heater and air conditioner
   Removal and installation of the heat exchanger of a heater
   Check of serviceability and service of systems of heating and air conditioning
   Diagnostics of system of automatic control in temperature (automatic telephone exchange) without its removal from the car
   Removal and installation of the accumulator (store) of central air of air
   Removal and installation of the compressor of central air of air
   Removal and installation of the condenser of central air of air
   Removal and installation of a tube of the calibrated jet
   Removal and installation of the evaporator of central air
+ the Power supply system and production of the fulfilled gases
+ System of electric equipment of the engine
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


Check of functioning of the water pump

Failure of the water pump can be at the bottom of the serious damages of the engine connected with its overheat.

There are some ways of check of functioning of the water pump without its removal from the engine. If the pump is faulty, it is necessary to replace it new or restored.

Water pumps are equipped control or ventilating with openings. In case of failure of an epiploon of the pump from an opening the cooler starts to exude. In most cases to find and examine a control opening which is in the lower part of the pump, the small lamp is required.

At emergence of malfunction of an epiploon of a shaft of the water pump from its control opening the cooler starts to exude.

If bearings of shaft of the water pump are faulty, they can publish howl, which will start with a forward part of an impellent compartment at operation of the engine. Wear of a shaft is shown in the form of palpation up-down a pulley of the water pump. Do not confuse howl, published by bearings with the squeal which is taking place at a proskalzyvaniye of a driving belt.

Grasp a flange of the pump try to shake its shaft up-down for identification of signs it люфта.

There is a probability of an exit of the pump out of operation when it is not accompanied by characteristic signs (howl also cooler infiltration through a control opening). Corrosion of a back part of shovels of a rotor of the pump, giving in a certain stage of the development to inadmissible decrease in efficiency of functioning of the pump sometimes takes place. The only way to check the such assumption removal of the pump and careful research of its condition is.