Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
- System of electric equipment of the engine
   General information
   Engine start from an auxiliary source
   Check of a condition and replacement of wires of the battery
   Removal and battery installation
   Ignition system - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the sensor of provision of a camshaft
   Removal and distributor installation
   Charge system - the general information and precautionary measures
   Check of serviceability of functioning of system of a charge
   Removal and generator installation
   Start system
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and starter installation
   Removal and installation of the traction relay (engines in volume of 4.0 l)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


Start system

The starters established on engines by volume of 4.0 l have the facilitated design with a planetary shesterenchaty drive. Such assemblies of a starter / the traction relay, made by the Mitsubishi company, provide high speed of a provorachivaniye of the engine at its start.

The block is equipped with the demountable traction relay which can be got in an individual order (ask in shops of automobile accessories). On engines in volume of 5.2 l the starter of Nippondenso firm equipped with a reducer where for achievement of desirable effect target gear wheels of different diameter This starter are used is established is the monolithic block. Before starting starter dismantle on your car consult in dealer office.

The unique system designation of start is the engine provorachivaniye with a speed, sufficient for its start.

The system of start consists of the battery, a starter, the traction relay and connecting wires. The traction relay fastens directly to a starter.

Starter assembly with the traction relay is established in the top part of the engine, in the neighbourhood with a transmission dome.

At ignition key turn in the situation START there is a zapityvaniye of the traction relay which carries out giving of a food of the battery on a starter. The starter starts to rotate, scrolling the engine.

At work with components of system of start it is necessary to remember the next moments:

  • The excessive provorachivaniye of a starter can lead to its overheat that is fraught with serious damages. Do not include a starter continuously more long than on 15 seconds. The pause between two long inclusions should make not less than 2 minutes.
  • The starter is connected directly to the battery and at maloperation, overloads and short circuit can cause formation of an electric arch that is fraught with a fire.

Before starting service any of components of system of start surely disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped with a security code before disconnecting from the battery a negative wire make sure that this code know.