Jeep Grand Cherokee

1993-1999 of release

Repair and car operation



Jeep Grandee Cheroki
+ Jeep Grand Cherokee brand Cars
+ Settings and routine maintenance
+ Ryadny six-cylinder engine
+ V8 Engine
+ Procedures of the general and major maintenance of the engine
+ Systems of cooling, heating and air conditioning
+ the Power supply system and production of the fulfilled gases
- System of electric equipment of the engine
   General information
   Engine start from an auxiliary source
   Check of a condition and replacement of wires of the battery
   Removal and battery installation
   Ignition system - the general information
   Check of serviceability of functioning of system of ignition
   Check of serviceability and replacement of the coil of ignition
   Check of serviceability and replacement of the sensor of provision of a camshaft
   Removal and distributor installation
   Charge system - the general information and precautionary measures
   Check of serviceability of functioning of system of a charge
   Removal and generator installation
   Start system
   Diagnostics of malfunctions of a starter without its removal from the car
   Removal and starter installation
   Removal and installation of the traction relay (engines in volume of 4.0 l)
+ Systems of decrease in toxicity of the fulfilled gases and engine management
+ Manual box of gear shifting
+ Automatic transmission
+ Transfer case
+ Coupling and transmission line
+ Brake system
+ Suspension bracket and steering
+ Body
+ System of onboard electric equipment
+ Governing bodies and operation receptions


Removal and installation of the traction relay (engines in volume of 4.0 l)

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.

If the radio tape recorder in your car is equipped with a security code before disconnecting from the battery a negative wire make sure that this code know.

  1. Remove a starter (The section Removal and starter installation).
  2. Disconnect the tire going from the traction relay to the plug of a starter.
  1. For separation of the traction relay from a starter remove a starter and disconnect the tire from the starterny plug of the relay (shooter).
  1. Give screws of fastening of the traction relay to a starter and remove the relay.
  1. For a detachment of the traction relay from a starter give fixing screws (shooters) in its forward part (the Mitsubishi firm starter is shown).
  1. Having removed the traction relay check a condition of a teeth of a gear wheel of a starter. If a teeth is damaged, it is necessary to examine also gear wreath of a flywheel / a driving disk.
  2. Installation make upside-down.